The CSA MC CiscoWorks component does not require any explicit configuration to communicate with the Security Monitor. All configuration is performed within the Security Monitor itself. To configure the Security Monitor to communicate with the CSA MC, open the Security Monitor from the VMS drawer on the server, as shown in Figure B-1.
When the Security Monitor application opens, follow these steps, which correspond to Figure B-2:
Step 1. | Click Devices > Add. |
Step 2. | Choose Cisco SA MC > Next. |
Step 3. | Enter the information required into the Add Device page, as follows:
|
Step 4. | Click Finish to complete the device configuration. |
After the sensor has been added, you should see the device listed either alone or with your other monitored devices, as in Figure B-3.
18.218.196.182