lane client
To activate a LANE client on the specified subinterface, use the lane client interface configuration command. To remove a previously activated LANE client on the subinterface, use the no form of this command.
lane client {ethernet | tokenring} [elan-name]
no lane client [{ethernet | tokenring} [elan-name]]
| Syntax | Description |
|---|---|
| ethernet | Identifies the emulated LAN attached to this subinterface as an Ethernet emulated LAN. |
| tokenring | Identifies the emulated LAN attached to this subinterface as a Token Ring emulated LAN. |
| elan-name | (Optional) Name of the emulated LAN. This argument is optional because the client obtains its emulated LAN name from the configuration server. The maximum length of the name is 32characters. |
Default
No LANE clients are enabled on the interface.
Command Mode
Interface configuration
Usage Guidelines
This command first appeared in Cisco IOS Release 11.0.
If a lane client command has already been used on the subinterface for a different emulated LAN, then the client initiates termination procedures for that emulated LAN and joins the new emulated LAN.
If you do not provide an elan-name value, the client contacts the server to find which emulated LAN to join. If you do provide an emulated LAN name, the client consults the configuration server to ensure that no conflicting bindings exist.
Example
The following example enables a Token Ring LANE client on an interface:
lane client tokenring
Related Commands
You can search online at http://www.cisco.com to find documentation of related commands.
lane client-atm-address