Use the mpoa client name interface configuration command to attach an MPC to a major ATM interface. Use the no form of this command to break the attachment.
mpoa client namempc-name
no mpoa client name mpc-name
Syntax | Description |
---|---|
mpc-name | Specifies the name of an MPC. |
No MPC is attached to an ATM interface.
Interface configuration
This command first appeared in Cisco IOS Release 11.3(3a)WA4(5).
The mpoa client name command provides an interface to the MPC through which the MPC can set up and receive calls.
When you enter this command on a major interface that is up and operational, the named MPC becomes operational. Once the MPC is fully operational, it can register its ATM address.
The following example attaches the MPC ip_mpc to an interface:
mpoa-client-config#interface atm 1/0
config-if#mpoa client name ip_mpc
18.227.46.227