To configure and troubleshoot a Cisco internetwork, you need to know the major components of Cisco routers and understand what each one does. Table 5.1 describes the major Cisco router components.
Table 5.1 Cisco router components
Component
Description
Bootstrap
Stored in the microcode of the ROM, the bootstrap is used to bring up a router during initialization. It will boot the router and then load the IOS.
POST (power-on self-test)
Stored in the microcode of the ROM, the POST is used to check the basic functionality of the router hardware and determines which interfaces are present.
ROM monitor
Stored in the microcode of the ROM, the ROM monitor is used for manufacturing, testing, and troubleshooting.
Mini-IOS
Called the RXBOOT or bootloader by Cisco, the mini-IOS is a small IOS in ROM that can be used to bring up an interface and load a Cisco IOS into flash memory. The mini-IOS can also perform a few other maintenance operations.
RAM (random access memory)
Used to hold packet buffers, ARP cache, routing tables, and also the software and data structures that allow the router to function. Running-config is stored in RAM, and most routers expand the IOS from flash into RAM upon boot.
ROM (read-only memory)
Used to start and maintain the router. Holds the POST and the bootstrap program as well as the mini-IOS.
Flash memory
Stores the Cisco IOS by default. Flash memory is not erased when the router is reloaded. It is electronically erasable programmable read-only memory (EEPROM) created by Intel.
NVRAM (nonvolatile RAM)
Used to hold the router and switch configuration. NVRAM is not erased when the router or switch is reloaded and does not store an IOS. The configuration register is stored in NVRAM.
Configuration register
Used to control how the router boots up. This value can be found as the last line of the show version command output and by default is set to 0x2102, which tells the router to load the IOS from flash memory as well as to load the configuration from NVRAM.
