2.1 Some typical resistivities for a range of materials
4.1 Mains power connecters around the world
7.1 DUS, DUG, TUN, TUP acronyms
7.2 DUS and DUG diode specifications
7.3 TUN and TUP transistor specifications
7.4 Crossing wires on schematic diagrams
7.5 Circuit layout component symbols
8.1 Resistance measurement results for two hand-held DMMs
9.1 The four fundamental electrical quantities
12.1 Resistor E-series preferred values Resistor E-series preferred values Resistor E-series preferred values
12.2 E-series and standard tolerances
12.3 Resistor colour codes
13.1 Capacitor types
13.2 Capacitor uses
13.3 Charge/discharge levels corresponding to various multiples of τ
14.1 Specifications for a range of transformers
15.1 Switch styles
15.2 Switch circuit symbols
16.1 Various diode specifications
17.1 Some typical BJT specifications
17.2 Simplified behaviour of an NPN BJT
17.3 Some typical JFET specifications
17.4 Some example MOSFET specifications
18.1 Selected ICs
18.2 Inverting opamp parameters in the voltage divider rule
18.3 Noninverting opamp parameters in the voltage divider rule
18.4 Some 4000 series ICs
18.5 AND and NAND gate truth table
20.1 Effect of different pickup combinations
20.2 Identifying the ends of a coil pickup winding
A.1 Multipliers (factors of 1,000)
A.2 Multipliers (factors of 10 and 100)
B.1 Primary quantities
C.1 Schematic symbol reference chart
18.188.175.182