Time Code — AATON ORIGIN C Unit
The AATON ORIGIN C unit is used to carry the exact time from the time code unit in the Nagra IV-S T.C. recorder to the Generator unit in the camera.
The ORIGIN C unit may also be used to reset the date and the time settings in the Nagra, if required.
Original data can be entered into the ORIGIN C unit as follows:
Resetting the Nagra Time and Date Settings
To reset the Nagra time and date settings from the ORIGIN C unit (which should already have been set correctly) plug it into the 5 pin LEMO socket on the right-hand side of the Nagra and press the “*” key. The ORIGIN C display should read bAd..........REIoAd.
While REloAd is displayed again press the “*” key on the ORIGIN C. The display will say In Control....Good.
The ORIGIN C unit may then be disconnected from the Nagra and used to set the camera.
Periodically Checking Time Code Sync
Every two or three hours, or when convenient, the Time Code sync should be checked to be sure it is running and good:
3.129.211.87