- Cover image
- Title page
- Table of Contents
- Copyright
- Contributors
- 1: Introduction
- Section I: Power Electronic Devices
- 2: Semiconductor Diodes and Transistors
- 3: Thyristors
- 4: Static Induction Devices
- Abstract
- 4.1 Introduction
- 4.2 Theory of Static Induction Devices
- 4.3 Characteristics of SIT
- 4.4 Bipolar Mode Operation of SI devices (BSIT)
- 4.5 Emitters for Static Induction Devices
- 4.6 Static Induction Diode
- 4.7 Lateral Punch-Through Transistor
- 4.8 Static Induction Transistor Logic
- 4.9 BJT Saturation Protected by SIT
- 4.10 Static Induction MOS Transistor
- 4.11 Space Charge Limiting Load (SCLL)
- 4.12 Power MOS Transistors
- 4.13 Static Induction Thyristor
- 4.14 Gate Turn Off Thyristor
- 5: SiC and GaN Power Semiconductor Devices
- 6: Power Electronic Modules
- Section II: Power Conversion
- 7: Diode Rectifiers
- 8: Single-Phase Controlled Rectifiers
- 9: Three-Phase Controlled Rectifiers
- 10: DC-DC Converters
- 11: Inverters
- 12: Resonant and Soft-Switching Converters
- Abstract
- 12.1 Introduction
- 12.2 Classification
- 12.3 Resonant Switch
- 12.4 Quasi-Resonant Converters
- 12.5 ZVS in High Frequency Applications
- 12.6 Multi-resonant Converters
- 12.7 Zero-voltage-transition Converters
- 12.8 Non-dissipative Active Clamp Network
- 12.9 Load Resonant Converters
- 12.10 Control Circuits for Resonant Converters
- 12.11 Extended-Period Quasi-Resonant Converters
- 12.12 Soft-Switching and EMI Suppression
- 12.13 Snubbers and Soft-Switching for High Power Devices
- 12.14 Soft-Switching DC-AC Power Inverters
- 13: Multilevel Power Converters
- 14: AC-AC Converters
- 15: Multiphase Converters
- 16: Power Factor Correction Circuits
- 17: Magnetic Circuit Design for Power Electronics
- Section III: General Applications
- Section IV: Power Generation and Distribution
- 23: Energy Sources
- 24: Photovoltaic System Conversion
- Abstract
- 24.1 Introduction
- 24.2 Solar Cell Characteristics
- 24.3 Photovoltaic Technology Operation
- 24.4 Maximum Power Point Tracking Components
- 24.5 MPPT Controlling Algorithms
- 24.6 Grid-Connected Photovoltaic System
- 24.7 Stand-Alone Photovoltaic System
- 24.8 Factors Affecting PV Output
- 24.9 PV System Design
- 25: Power Electronics for Renewable Energy Sources
- 26: Electric Power Transmission
- Abstract
- 26.1 Elements of Power System
- 26.2 Generators and Transformers
- 26.3 Transmission Line
- 26.4 Factors That Limit Power Transfer in Transmission Line
- 26.5 Effect of Temperature on Conductor Sag or Tension
- 26.6 Standard and Guidelines on Thermal Rating Calculation
- 26.7 Optimizing Power Transmission Capacity
- 26.8 Overvoltages and Insulation Requirements of Transmission Lines
- 26.9 Methods of Controlling Overvoltages
- 26.10 Insulation Coordination
- 27: HVDC Transmission
- Abstract
- Acknowledgments
- 27.1 Introduction
- 27.2 Main Components of HVDC Converter Station
- 27.3 Analysis of Converter Bridge
- 27.4 Controls and Protection
- 27.5 MTDC Operation
- 27.6 Application
- 27.7 Modern Trends
- 27.8 VSC-HVDC System
- 27.9 Control of VSC-HVDC System
- 27.10 HVDC System Simulation Techniques
- 27.11 Concluding Remarks
- 28: Flexible AC Transmission Systems
- Section V: Motor Drive
- 29: Drive Types and Specifications
- 30: Motor Drives
- Abstract
- 30.1 Introduction
- 30.2 DC Motor Drives
- 30.3 Induction Motor Drives
- 30.4 Synchronous Motor Drives
- 30.5 Permanent-Magnet Synchronous Motor Drives
- 30.6 Permanent-Magnet Brushless DC Motor Drives
- 30.7 Servo Drives
- 30.8 Stepper Motor Drives
- 30.9 Switched-Reluctance Motor Drives
- 30.10 Synchronous Reluctance Motor Drives
- 31: Fundamentals of Power Electronics Controlled Electric Propulsion
- 32: Automotive Applications of Power Electronics
- Abstract
- 32.1 Introduction
- 32.2 The Present Automotive Electrical Power System
- 32.3 System Environment
- 32.4 Functions Enabled by Power Electronics
- 32.5 Multiplexed Load Control
- 32.6 Electromechanical Power Conversion
- 32.7 Dual/High Voltage Automotive Electrical Systems
- 32.8 Electric and Hybrid Electric Vehicles
- 32.9 Summary
- 33: Fuel-Cell Systems for Transportations
- 34: Wireless Charging of Electric Vehicles
- Section VI: Control
- 35: Linear and Nonlinear Control of Switching Power Converters
- Abstract
- Acknowledgments
- 35.1 Introduction
- 35.2 Switching Power Converter Control Using State-Space Averaged Models
- 35.3 Sliding-Mode Control of Switching Power Converters
- 35.4 Predictive Optimum Control of Switching Power Converters
- 35.5 Fuzzy Logic Control of Switching power converters
- 35.6 Backstepping Control of Switching Power Converters
- 35.7 Conclusions
- 36: Fuzzy-Logic Applications in Electric Drives and Power Electronics
- Abstract
- Acknowledgments
- 36.1 Introduction
- 36.2 PI/PD-Like Fuzzy Control Structure
- 36.3 FNN PI/PD-Like Fuzzy Control Architecture
- 36.4 Learning Algorithm-Based EKF
- 36.5 Fuzzy PID Control Design-Based Genetic Optimization
- 36.6 Classical PID Versus Fuzzy-PID Controller
- 36.7 Genetic-Based Autotuning of Fuzzy-PID Controller
- 36.8 Fuzzy and H∞ Control Designâ Control Design
- 36.9 Fuzzy Control for DC-DC Converters
- 36.10 Fuzzy Control Design for Switch-Mode Power Converters
- 36.11 Optimum Topology of the Fuzzy Controller
- 36.12 Adaptive Network-Based Fuzzy Control System for DC-DC Converters
- 36.13 Summary
- 37: Artificial Neural Network Applications in Power Electronics and Electric Drives
- 38: Novel AI-Based Soft Computing Applications in Motor Drives
- Abstract
- 38.1 Introduction
- 38.2 Differences Between GA and PSO and Other Evolutionary Computation Techniques
- 38.3 Single Objective Genetic Optimization Search Algorithm (SOGA)
- 38.4 Single Objective Particle Swarm Optimization Search Algorithm (SOPSO)
- 38.5 Multiobjective Optimization (MOO)
- 38.6 Multiobjective Genetic Optimization Search Algorithm (MOGA)
- 38.7 Multiobjective Particle Swarm Optimization Search Algorithm (MOPSO)
- 38.8 GA and PSO Applications in Speed Control of Motor Drives
- 38.9 Conclusion
- 39: DSP-Based Control of Variable Speed Drives
- Abstract
- 39.1 Introduction
- 39.2 Variable Speed Control of AC Machines
- 39.3 General Structure of a Three-Phase AC Motor Controller
- 39.4 DSP-Based Control of Permanent Magnet Brushless DC Machines
- 39.5 DSP-Based Control of Permanent Magnet Synchronous Machines
- 39.6 DSP-Based Vector Control of Induction Motors
- 40: Predictive Control of Power Electronic Converters
- 35: Linear and Nonlinear Control of Switching Power Converters
- Section VII: Power Quality and EMI Issues
- Section VIII: Simulation and Packaging
- 44: Computer Simulation of Power Electronics and Motor Drives
- Abstract
- 44.1 Introduction
- 44.2 Use of Simulation Tools for Design and Analysis
- 44.3 Simulation of Power Electronics Circuits With LTspice
- 44.4 Simulations of Power Electronic Circuits and Electric Machines
- 44.5 Simulations of AC Induction Machines Using Field Oriented (Vector) Control
- 44.6 Simulation of Sensorless Vector Control Using LTspice
- 44.7 Conclusions
- 45: Design for Reliability of Power Electronic Systems
- 46: Thermal Modeling and Analysis of Power Electronic Components and Systems
- Abstract
- 46.1 Introduction
- 46.2 Background
- 46.3 Semiconductor Device Modelling
- 46.4 Magnetic Components
- 46.5 Thermal Conduction
- 46.6 Convection
- 46.7 Radiation
- 46.8 Steady State Thermal Circuit Modeling
- 46.9 Dynamic Thermal Circuit Modeling
- 46.10 Approximating Distributed Thermal Behaviour Using Ladder Networks
- 46.11 Transient Thermal Impedance
- 46.12 Procedure to Calculate the Transient Thermal Impedance
- 46.13 Finite Element Numerical Methods
- 46.14 Dynamic Thermal Equivalent Circuit Models
- 46.15 Summary
- 44: Computer Simulation of Power Electronics and Motor Drives
- Index
Power Electronics Handbook
Fourth Edition
Muhammad H. Rashid, Ph.D.
Fellow IET (UK), Life Fellow IEEE, Florida Polytechnic University
-
No Comment
..................Content has been hidden....................
You can't read the all page of ebook, please click here login for view all page.